7. Connect the power and hard-drive cables to the drive.
8. Check all connectors to be certain that they are properly cabled and firmly seated.
9. Close the computer cover.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the
computer.
10. Connect your computer and devices to electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
Floppy Drive
http://support.dell.com/support/edocs/systems/dimxpsg2/en/SM/parts.htm (14 of 37) [3/26/2008 3:57:09 PM]
To Next Page
Loading...
