Dell E33S001 - Supported Configurations on Poweredge R230 Systems; Front Panel Features and Indicators

Supported congurations on PowerEdge R230
systems
NOTE: Your system supports internal, hot swappable hard drives and cabled hard drives.
Table 1. Supported congurations on PowerEdge R230 systems
PowerEdge R230 Systems Congurations
Two hard drive systems Up to two 3.5-inch cabled hard drives with non-redundant cabled power supply unit (PSU)
Four hard drive systems Up to four 3.5- inch cabled hard drives with non-redundant cabled PSU
Up to four 2.5-inch hot swappable hard drives in 3.5-inch hard drive adapters, with non-redundant
cabled PSU
Up to four 3.5-inch hot swappable hard drives with non-redundant cabled PSU
Front panel features and indicators
Figure 2. Front panel features and indicators — four 3.5-inch or 2.5-inch hot swappable hard drive chassis
Table 2. Front panel features and indicators — four 3.5-inch or 2.5-inch hot swappable hard drive chassis
Item Indicator, button, or connector Icon Description
1 Power-on indicator, power
button
Enables you to know the power status of the system. The power-
on indicator glows when the system power is on. The power button
controls the power supply output to the system.
NOTE: On ACPI-compliant operating systems, turning o
the system using the power button causes the system to
perform a graceful shutdown before power to the system
is turned o.
2 NMI button
Enables you to troubleshoot software and device driver errors when
running certain operating systems. This button can be pressed by
using the end of a paper clip.
Use this button only if directed to do so by qualied support
personnel or by the operating system's documentation.
3 System identication button Enables you to locate a particular system within a rack. The
identication buttons are on the front and back panels. When one
of these buttons is pressed, the LCD panel on the front and the
10 About the PowerEdge R230 systems