Steps
1 Open the expansion card riser latch.
2 Align the following:
a Guide on the expansion card riser with the guide pin on the system board.
b Expansion card riser connector with the connector on the system board.
3 Lower the expansion card riser until the expansion card riser is rmly seated in the connector on the system board.
4 Close the expansion card riser latch.
Figure 53. Installing the expansion card riser
1
expansion card riser 2 guide on the expansion card riser
3 guide pin on the system board 4 riser connector on the system board
5 slot on the chassis 6 expansion card latch
Next steps
Follow the procedure listed in the After working inside your system section.
1 If removed, connect the PERC card LED cable.
2 Follow the procedure listed in the After working inside your system section.
Related links
Installing an expansion card
Removing an expansion card
Prerequisites
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 Disconnect any cables connected to the expansion card or expansion card riser.
4 If installed, remove the expansion card riser.
Installing and removing system components
97
To Next Page
Loading...
