Dell E33S001 - Removing the Expansion Card Riser

Card priority Card type Slot priority Maximum allowed
9 1 Gb NIC (Broadcom quad
port)
2 1
10 1 Gb NIC (Broadcom low
prole)
1 1
11 1 Gb NIC (Intel dual port) 2 1
12 1 Gb NIC (Intel dual port,
low prole)
1 1
13 1 Gb NIC (Broadcom dual
port)
2 1
14 1 Gb NIC (Broadcom dual
port, low prole)
1 1
15 12 Gb SAS (full height) 2 1
16 12 Gb SAS (low prole) 1 1
Removing the expansion card riser
Prerequisites
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 Disconnect the PERC card LED cable.
NOTE
: This step is applicable only to the cabled hard drive systems.
Steps
1 Lift and rotate the expansion card riser latch to open it.
2 Holding the touch points, lift the expansion card riser from the riser connector on the system board.
Installing and removing system components
95