Figure 62. Removing and installing a heat sink
1 captive screw (4) 2 heat sink
3 processor socket 4 slot (4)
Next steps
1 If you are removing only a faulty heat sink, install the replacement heat sink, if not, remove the processor.
2 Follow the procedure listed in the After working inside your system section.
Related links
Removing the cooling shroud
Installing the heat sink
Installing the processor
Installing the cooling shroud
Removing the processor
Prerequisites
CAUTION
: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell certied
service technicians.
1 Follow the safety guidelines listed in the Safety instructions section.
2 If you are upgrading your system, download the latest system BIOS version from Dell.com/support and follow the instructions
included in the compressed download le to install the update on your system.
NOTE
: You can update the system BIOS by using the Dell Lifecycle Controller.
3 Follow the procedure listed in the Before working inside your system section.
4 Remove the cooling shroud.
5 Remove the heat sink.
6 Keep the Phillips #2 screwdriver ready.
106
Installing and removing system components
To Next Page
Loading...
