Figure 48. Removing a cooling fan
Next steps
1 Install the cooling fan.
2 Follow the procedure listed in the After working inside your system section.
Related links
Removing the cooling shroud
Installing a cooling fan
Installing the cooling shroud
Installing a cooling fan
Prerequisites
NOTE
: The procedure for installing each fan is identical.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 Remove the cooling shroud.
4 If installed, remove the cooling fan blank.
Steps
1 Lower the fan into the cooling fan bracket.
2 Connect the power cable to the power cable connector on the system board.
Installing and removing system components
91
To Next Page
Loading...
