Dell E33S001 - Installing a 2.5-Inch Hot Swappable Hard Drive into a 3.5-Inch Hard Drive Adapter

Figure 35. Installing a hot swappable hard drive carrier
1 release button 2 hard drive carrier
3 hard drive carrier handle
Next step
If removed, install the front bezel.
Related links
Installing a hot swappable hard drive into a hot swappable hard drive carrier
Installing the optional front bezel
Installing a 2.5-inch hot swappable hard drive into a 3.5-inch
hard drive adapter
Prerequisites
CAUTION
: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Keep the Phillips #2 screwdriver ready.
Steps
1 Align the screw holes on the 2.5-inch hot swappable hard drive with the screw holes on the 3.5-inch hard drive adapter.
2 Install the screws to secure the 2.5-inch hot swappable hard drive to the 3.5-inch hard drive adapter.
78
Installing and removing system components