Dell E75S001 - Page 82

Table 28. Expansion card riser configurations (continued)
Configuratio
ns
Expansion
card risers
PCIe Slots Controlling
processor
Height Length Slot width Power
4 Processor 2 Low profile Half length x16 75 W
Config1. R1B 3 Processor 1
and 2
Low profile Half length x16 75 W
4 Processor 1 Low profile Half length x8 75 W
Config2. R1B 3 Processor 1
and 2
Low profile Half length x16 75 W
4 Processor 1 Low profile Half length x8 75 W
Config3. R1A 3 Processor 1 Low profile Half length x16 75 W
4 Processor 2 Low profile Half length x16 75 W
Config4. NA NA NA NA NA NA NA
NA NA NA NA NA NA
Config5. NA NA NA NA NA NA NA
NA NA NA NA NA NA
NOTE: Only one cable riser can be installed at a time in any given configuration.
NOTE: R1B is a SNAPI riser.
NOTE: Config 4 and 5 are no riser configuration.
Figure 78. Riser 1A
1. Slot 3
2. Slot 4
82
Installing and removing system components