front bezels should always be attached to ensure EMI compliance. Make sure you reattach the bezel after replacing a
component. Also, each slot should contain a component or filler panel to ensure proper air flow throughout the system.
Unpacking a part
Use these best practices to unpack a part.
Steps
1. Wear ESD gloves or attach an ESD wristband to your wrist and the enclosure in which you are installing the part.
2. Unpack the part and place it on a static-free surface.
3. If the part is a replacement for a faulted part, save the packing material to return the faulted part.
98 Safety precautions for handling replaceable units
To Next Page
Loading...
