About this guide
This guide provides site preparation recommendations, step-by-step procedures for rack mounting and desk mounting, inserting
optional modules, and connecting to a power source.
CAUTION: To avoid electrostatic discharge (ESD) damage, wear grounding wrist straps when handling this
equipment.
NOTE: Only trained and qualified personnel can install this equipment. Read this guide before you install and power up this
equipment. This equipment contains two power cords. Disconnect both power cords before servicing.
NOTE: This equipment contains optical transceivers, which comply with the limits of Class 1 laser radiation.
Figure 1. Class 1 laser product tag
NOTE: When no cable is connected, visible and invisible laser radiation may be emitted from the aperture of the optical
transceiver ports. Avoid exposure to laser radiation and do not stare into open apertures.
Regulatory
● Regulatory Model No. Z9100
● Marketing Model No. Z9100
Topics:
• Related documents
Related documents
For more information about the Z9100–ON switch, see the following documents:
● Dell Networking Getting Started Guide for the Z9100–Open Networking (ON) System
● Dell Networking Release Notes for the Z9100–Open Networking (ON) System
● Dell Networking Command Line Reference Guide for the Z9100–Open Networking (ON) System
● Dell Networking Configuration Guide for the Z9100–Open Networking (ON) System
● Open Networking Hardware Diagnostic Guide for the Z9100–ON System
NOTE: For the most recent documentation, visit Dell EMC support: www.dell.com/support.
1
About this guide 5
To Next Page
Loading...
Need help?
General