20 | Installing Power Modules
www.dell.com | support.dell.com
AC Power Requirements
AC Power Cord Requirements
Each AC power supply is shipped with a Dell Force10-approved AC power cord and only that cord
should be used to connect the AC power supply to the appropriate AC outlet. The power source end of the
power cord must have an appropriately sized plug that complies with your local electrical codes.
Conductor size must also conform to your local electrical codes.
CAUTION: The power cord is the main power disconnect device; ensure that the socket-outlet is located/
installed near the equipment and is easily accessible.
The following are Dell Force10 supplied plug types. All power plugs must comply with local codes.
Check with your Dell Force10 representative to purchase cords or plugs for your system.
• EU: CEE7/7
• UK: CEE7/7, UK plug
• SWZ: CEE7/7
• JAP: C14, C20, NEMA 5-15, L5-20
• JAP 220: NEMA 6-20, L6-20
• US: C14, C20, NEMA 5-15, L5-20
• US 220: NEMA 6-20, L6-20
CAUTION: The power cord is the main power disconnect device; ensure that the socket-outlet is located/
installed near the equipment and is easily accessible.
Parameters Specifications
Nominal Input Voltage 100 - 120 VAC Requires a minimum of 3 Power Supplies Installed
200 - 240 VAC Requires a minimum of 2 Power Supplies Installed
Maximum AC Power Supply Input 10 A @ 100 VAC per module
7 A @ 200 VAC per module
Maximum System Power Input 4.80 KVA @ 100 VAC
4.60 KVA @ 220 VAC
To Next Page
Loading...
