Dell Latitude 3300 - Removing and Installing Display Assembly

5 Install the:
a battery
b base cover
c micro-SD card
6 Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
NOTE
: This process is for both touch and non-touch LCDs.
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a micro-SD card
b base cover
c battery
d WLAN card
e DC-in cable
3 Remove the tape [1] and unroute the antennae cable [2] near the fan case.
4 Remove the single screw that secures the EDP bracket [3] and remove it o the EDP connector on the system board [4].
5 Disconnect the EDP cable from the system board [5].
Disassembly and reassembly
101