Dell Latitude 3300 - Turning off Your Computer; Turning off Your Computertablet Tablet- Windows

Command Line Interface
This chapter provides a general overview of the Command Line Interface (CLI) utility. It explains how to run the commands and the syntax
details of the command line options used to congure BIOS settings for the client systems.
Running Command | Congure Commands
You can run the Command | Congure commands in two ways:
• Using Command Prompt
• Using Bootable Image
Command Prompt
To run Command | Congure commands:
1 Click Start → All Program → Dell → Command Congure → Command Congure Command Prompt.
NOTE: If you are using Microsoft Windows Vista operating system or later, right-click Command | Congure Command
Prompt and select Run as administrator.
2 Navigate to the x86 or x86_64 directory depending on the architecture of the operating system.
3 Run the Command | Congure commands.
Bootable Image
To run Command | Congure commands:
1 Copy Dell Command | Congure with the International Organization for Standardization (ISO) image to a Compact disc (CD). For
more information, see Dell Command | Congure Installation Guide available at https://Dell.com/Command .
2 Boot the system that you want to congure from the CD.
3 Navigate to the Command Congure\x86 or Command Congure\x86_64 directory.
4 Run the Command | Congure commands.
Turning o your computer
Turning o your computertablet tablet— Windows
CAUTION
: To avoid losing data, save and close all open les and exit all open programs before you turn o your computer or
remove the side cover.
1 Click or tap .
2 Click or tap and then click or tap Shut down.
NOTE
: Ensure that the computer and all attached devices are turned o. If your computer and attached devices did not
automatically turn o when you shut down your operating system, press and hold the power button for about 6 seconds
to turn them o.
50 Technology and components