NOTE: Keyboard cable must be inserted parallel to the connector.
NOTE: Remove the anti adhesive paper on the keyboard before inserting the cable.
NOTE: After the cable is inserted, the operator must hold the cable with left and press the actuator down by the right
hand to avoid cable loosening.
5 Install the:
a micro-SD card
b base cover
c battery
6 Follow the procedure in After working inside your computer.
Touch pad
Removing the touch pad
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a micro-SD card
b base cover
c battery
3 Lift the actuator and disconnect the touch pad cable from the system board [1].
4 Remove the tape [2,3,4] securing the touch pad to the chassis.
82
Disassembly and reassembly
To Next Page
Loading...
