b base cover
8 Follow the procedure in After working inside your computer.
Coin Cell
Removing the coin cell
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a micro-SD card
b base cover
c battery
3 Disconnect the battery cable from its connector on the system board [1].
4 Lift and remove the coin cell from the system [2].
NOTE: A strong adhesive is used on the coin cell; a bit of force is needed to peel up the battery from the palmrest.
Installing the coin cell
1 Place the coin cell battery into the system.
2 Connect the coin cell battery cable to the connector on the system board.
68
Disassembly and reassembly
To Next Page
Loading...
