Diagnostic LEDs
Instead of beep codes, errors are indicated via the bicolor Battery Charge/Status LED. A specic blink pattern is followed by ashing a
pattern of ashes in amber, followed by white. The pattern then repeats.
NOTE: The diagnostic pattern will consist of a two-digit number being represented by a rst group of LED blinks (1 through 9) in
amber, followed by a 1.5 second pause with the LED o, and then a second group of LED blinks (1 through 9) in white. This is
then followed by a three second pause, with the LED o, before repeating over again. Each LED blink takes 1.5 seconds.
The system will not shutdown when displaying the Diagnostic Error Codes.
Diagnostic Error Codes will always supersede any other use of the LED. For instance, on Notebooks, battery codes for Low Battery or
Battery Failure situations will not be displayed when Diagnostic Error Codes are being displayed.
Table 51. Diagnostic LEDs
Blinking Pattern Problem Description Suggested Resolution
Amber White
2 1 CPU failure Replace the system board
2 2 System board failure (included BIOS corruption or ROM error) Flash latest BIOS version. If problem persists,
replace the system board.
2 3 No memory/ RAM detected Conrm that the memory module is installed
properly. If problem persists, replace the
memory module.
2 4 Memory/ RAM failure Replace the memory module.
2 5 Invalid memory installed Replace the memory module.
2 6 System board/ Chipset error Replace the system board.
2 7 LCD failure Replace the LCD module.
2 8 LCD Power rail failure Replace the system board
3 1 CMOS battery failure Replace the RTS battery.
3 2 PCI or Video card/ chip failure Replace the system board.
3 3 BIOS Recovery Image not found Flash latest BIOS version. If problem persists,
replace the system board.
3 4 BIOS Recovery Image found but invalid Flash latest BIOS version. If problem persists,
replace the system board.
TIP: For diagnostics pattern 2-amber, 8-white connect an external monitor to isolate between system board or graphics
controller failure.
M-BIST
M-BIST(Built In Self-Test) diagnostics tool, featuring improved accuracy in system board failures.
NOTE
: M-BIST can be manually initiated before POST(Power On Self Test).
How to run M-BIST
NOTE
: M-BIST must be initiated on the system from a power-o state that is either connected to AC power or with battery only.
144 Diagnostics
To Next Page
Loading...
