Dell Latitude 3300 - Installing the DC-In Cable

a micro-SD card
b base cover
c battery
3 Disconnect the DC-in cable from its connector on the system board [1].
4 Remove the two M2L4 screws securing the DC-in port to the palmrest and the system board [2].
5 Flip over the metal bracket on the USB Type-C port of the system board [3].
6 Lift to remove the DC-in port from the computer [4].
Installing the DC-in cable
1 Install the DC-in port in the computer [1] placing the metal bracket on the USB Type-C port of the system board [2].
2 Tighten the two M2xL4 screw securing the DC-in to the motherboard and palmrest [3].
3 Connect the DC-in cable to the system board [4].
94
Disassembly and reassembly