Installing system fan
1 Place the fan on the system board.
2 Tighten the M2xL3 screws to secure the fan to the system board.
3 Connect the fan cable to the system board.
4 Route the WLAN cable onto its hook on the system board.
5 Install the:
a battery
b base cover
c microSD card
6 Follow the procedure in After working inside your computer.
Hard disk drive (HDD)
Removing hard disk drive (HDD)
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a microSD card
b base cover
c battery
3 To remove the HDD:
a Disconnect the HDD cable from the system board [1].
b Remove the M2xL3 screws that secure the HDD to the palmrest [2].
c Lift the HDD from the computer [3].
20
Removing and installing components
To Next Page
Loading...
