Dell Latitude 3380 - Installing Display Assembly; System Board; Removing System Board

Installing display assembly
1 Place the display assembly to align with the screw holders on the computer.
2 Tighten the M1.6xL2 screws to secure the display assembly to the computer.
3 Turn over the computer
4 Connect the display cable to the connector.
5 Place the metal bracket over the connector and tighten the screw to secure the display cable to the computer.
6 Install the:
a WLAN card
b DC-IN board
c battery
d base cover
e microSD card
7 Follow the procedure in After working inside your computer
System board
Removing system board
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a microSD card
b base cover
c battery
d WLAN card
e memory module
f heat sink
g fan
h DCin
3 Remove the screw that secures the metal bracket of the display cable [1] and remove it from the system [2]. Then, remove the eDP
cable from the system board [3] and disconnect the coin cell battery cable from its connector on the system board [4].
Removing and installing components
31