Installing speakers
1 Place the speakers into the slots on the computer.
2 Route the speaker cable through the routing channel.
3 Ax the adhesive tape to secure the speaker cable to the computer.
4 Connect the speaker cable to the connector on the system board.
5 Install the:
a battery
b base cover
c microSD card
6 Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
NOTE
: This process is for both nontouch and touch LCDs
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a microSD card
b base cover
c battery
d WLAN Card
e DC-IN board
3 Remove the screw that secures the metal bracket of the display cable [1] and remove it from the system [2]. Then, remove the cable
from the system board [3] and ip over the computer [4].
Removing and installing components
29
To Next Page
Loading...
