Dell Latitude 3380 - DC-In Board

Installing Embedded Multimedia Card assembly (eMMC)
1 Align the eMMC assembly to the system board.
2 Tighten the M2.0L3 screws that secure the eMMC assembly to the chassis.
3 Connect the interposer cable to its connector on the system board.
4 Install the:
a battery
b base cover
c microSD card
5 Follow the procedure in After working inside your computer.
DC-In Board
Removing DC in connector
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a microSD card
b base cover
c battery
3 To remove the DC-in connector:
a Disconnect the DC-in cable from its connector on the system board [1].
b Remove the M2.5xL5 screw that secures the DC-in connector to the display hinge [2].
c Lift and remove the DC-in connector from the system [3].
24
Removing and installing components