Installing hard disk drive (HDD)
1 Tighten the M3xL3 screws to attach the metal bracket to the HDD.
2 Connect the HDD cable interposer.
3 Insert the HDD into the slot on the computer.
4 Tighten the M2xL3 screws to secure the HDD to the computer.
5 Connect the HDD cable to the system board.
6 Install the:
a battery
b base cover
c microSD card
7 Follow the procedure in After working inside your computer.
eMMC assembly
Removing Embedded Multimedia Card (eMMC) assembly
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a microSD card
b base cover
c battery
3 Disconnect the interposer cable from the system board, remove the M2.0L3 screws that secure the bracket to the chassis and gently
lift the eMM card out.
22
Removing and installing components
To Next Page
Loading...
