Steps
1. Align the tabs on the battery with the slots on the palm rest assembly.
2. Place the battery in the battery bay.
3. Tighten the five (M2x3) screws to secure the battery to the palm rest assembly.
4. Connect the battery cable to the connector on the system board.
Next steps
1. Replace the base cover.
2. Replace the SD Card.
3. Follow the procedure in after working inside your computer
Memory modules
Removing the memory module
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SD Card.
3. Remove the base cover.
4. Disconnect the battery.
About this task
The following images indicate the location of the memory module and provide a visual representation of the removal procedure.
24
Disassembly and reassembly
To Next Page
Loading...
