Dell Latitude 3410 - Removing the Coin-cell Battery; Installing M.2 2280 Solid-state Drive; Removing the M.2 2230 Solid-state Drive

Steps
1. Align the notch on the WLAN card with the tab on the WLAN-card slot and insert the WLAN card at an angle into the
WLAN-card slot.
2. Connect the WLAN antenna cables to the WLAN card.
3. Align and place the WLAN-card bracket to secure the WLAN card to the system board.
4. Replace the single (M2x3) screw to secure the WLAN card to the system board.
Next steps
1. Reconnect the battery cable.
2. Install the base cover.
3. Install the SD Card
4. Follow the procedure in After working inside your computer.
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SD card.
28
Disassembly and reassembly