Steps
1. Place the system board onto the palmrest, aligning the screw posts from the palmrest. Place the metal shield onto the USB
port module and install the two (M2) screws. Install the two (M2.3x5) screws to secure the system board to the palmrest.
2. Connect the DC-in port connector back to the system board.
3. Fold the right hinge back, install the three (M2.5x5) to secure the hinge in place.
4. Connect the fan connector back to the system board.
5. Connect the LCD cable back to the system board.
6. Fold the LCD connectors latch to secure it in place.
7. Connect the IO board cable to the system board.
8. Connect the following cables in the following order (left - right): Speaker, Touchpad, USB, Battery, Keyboard.
Next steps
1. Install the Heatsink.
2. Install the WLAN card.
3. Install the Solid state drive.
4. Install the memory module.
5. Install the battery.
6. Install the base cover.
7. Install the SD Card.
8. Follow the procedure in After working inside your computer.
Removing the system board - UMA
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SD Card.
3. Remove the base cover.
4. Disconnect the battery.
5. Remove the memory modules.
6. Remove the WLAN card.
7. Remove the solid state drive.
8. Remove the heatsink.
About this task
The figure indicates the location of the system board and provides a visual representation of the removal procedure.
Disassembly and reassembly
53
To Next Page
Loading...
