Steps
1. Align the notch on the memory module with the tab on the memory module slot.
2. Slide the memory module firmly into the slot at an angle.
3. Press the memory module down until it clicks into place.
NOTE: If you do not hear the click, remove the memory module and reinstall it.
Next steps
1. Install the battery.
2. Install the base cover.
3. Install the SD Card.
4. Follow the procedure in After working inside your computer.
WLAN card
Removing the WLAN card
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SD card
3. Remove the base cover.
4. Disconnect the battery cable.
About this task
The figure indicates the location of the WLAN card and provides a visual representation of the removal procedure.
26
Disassembly and reassembly
To Next Page
Loading...
