Installing camera
About this task
Steps
1. Insert the camera into the slot on the display back cover .
2. Connect the camera cable to the connector on the camera module.
Next steps
1. Replace the display panel.
2. Replace the display bezel.
3. Replace the display assembly.
4. Replace the battery.
5. Replace the base cover.
6. Replace the SD card.
7. Follow the procedure in after working inside your computer.
Display (eDP) cable
Removing display cable
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
4. Remove the battery.
5. Remove the display assembly.
6. Remove the display bezel.
7. Remove the display panel.
8. Remove the camera.
74
Disassembly and reassembly
To Next Page
Loading...
