2. Lock the latch securing the EDP cable to the connector and reapply the adhesive tape over the connector.
3. Place the display panel screen-side up onto the display back cover. Replace the six (M2.5x2.5) and two (M2x2) screws to
secure the display panel to the display assembly.
Next steps
1. Replace the display bezel.
2. Replace the display assembly.
3. Replace the battery.
4. Replace the base cover.
5. Replace the SD card.
6. Follow the procedure in after working inside your computer.
Camera
Removing camera
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
4. Remove the battery.
5. Remove the display assembly.
6. Remove the display bezel.
7. Remove the display panel.
About this task
Steps
1. Disconnect the camera cable from the connector on the camera module.
2. Carefully pry and lift the camera module from the display back cover.
Disassembly and reassembly
73
To Next Page
Loading...
