Dell Latitude 3410 - Installing the DC-in; Installing the Hard Drive; Touchpad; Removing the Touchpad

Steps
1. Locate the DC-in port on your computer, remove the three (M2.5x5) screws from the hinge covering it.
2. Lift the hinge and fold it away from the chassis.
3. Disconnect the DC-in cable from the computer and remove the single (M2x3) screw.
4. Remove the DC-in port from the computer.
Installing the DC-in
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the DC-in port and provides a visual representation of the installation procedure.
Disassembly and reassembly
31