NOTE: For systems configured with a WWAN card, you must connect the cable from WWAN daughterboard to the
connector on the systemboard.
2. Connect the IO board cable to the system board.
3. Connect the fan connector back to the system board.
4. Fold the right hinge back, install the three (M2.5x5) to secure the hinge in place.
5. Connect the LCD cable back to the system board and fold the adhesive tape back onto the LCD connector.
6. Connect the DC-in port connector back to the system board and fold the adhesive tape back onto the DC-in connector.
7. Place the metal shield onto the USB port module.
8. Install the two (M2x4) screws to secure the metal shield.
9. Connect the following cables in the following order (left - right): Speaker, Touchpad, USB, Battery, Keyboard.
Next steps
1. Install the Heatsink.
2. Install the WLAN card.
3. Install the Solid state drive.
4. Install the memory module.
5. Install the battery.
6. Install the base cover.
7. Install the SD Card.
8. Follow the procedure in After working inside your computer.
IO Board
Removing the IO Board
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SD Card.
3. Remove the base cover.
Disassembly and reassembly
59
To Next Page
Loading...
