3. Follow the procedure in After working inside your computer.
Hard Drive
Removing the Hard Drive
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SD Card.
3. Remove the base cover.
4. Disconnect the battery.
About this task
The following images indicate the location of the hard drive and provide a visual representation of the removal procedure.
Steps
1. Remove the four M3x3 screws and disconnect the hard drive cable from the connector on the system board.
2. Remove the hard drive from the computer.
Installing the Hard Drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the Hard Drive and provides a visual representation of the installation procedure.
Disassembly and reassembly
37
To Next Page
Loading...
