About this task
The figure indicates the location of the heatsink and provides a visual representation of the installation procedure.
Steps
1. Place the heatsink onto the system board ensuring the mounting points on heatsink and system board align.
2. Tighten the seven captive screws to secure the heatsink to the system board.
Next steps
1. Install the battery.
2. Install the base cover.
3. Install the SD Card.
4. Follow the procedure in After working inside your computer.
Removing the Heatsink Assembly - UMA
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SD Card.
3. Remove the base cover.
4. Disconnect the battery.
About this task
The following images indicate the location of the heatsink and provide a visual representation of the removal procedure.
46
Disassembly and reassembly
To Next Page
Loading...
