Dell Latitude 3410 - Installing the Coin-cell Battery; Installing M.2 2230 Solid-state Drive; Installing M.2 Solid-state Drive Bracket

3. Remove the base cover.
4. Disconnect the battery cable.
About this task
The figure indicates the location of the coin-cell battery and provides a visual representation of the removal procedure.
Steps
1. Disconnect the coin-cell battery cable from the system board.
2. Peel the coin-cell battery off the palmrest assembly as the coin-cell is affixed to the board with an adhesive.
NOTE: CAUTION: The removal of the coin cell battery will result in an RTC error and will clear all CMOS settings.
Installing the coin-cell battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the coin-cell and provides a visual representation of the installation procedure.
Disassembly and reassembly
29