Installing the display panel
1. Place the display panel on a plane surface.
2. Connect the display cable to the connector on the system board
3. Connect the battery cable to the connector on the system board.
4. Install the display panel on the tablet and press the edges until they snap in.
5. Flip the tablet and open the kickstand.
6. Replace the M1.6 x 3.0 screws to secure the tablet to the display panel.
7. Install the:
a. uSIM/micro SD card
8. Follow the procedure in After working inside your tablet.
Removing the display cable
1. Follow the procedure in Before working inside your tablet.
2. Remove the:
a. uSIM and/or microSD card
b. display panel
3. Removing the display cable:
a. Peel the tape that secures the touch module cable [1].
b. Disconnect the touch module cable from the connector on the display panel [2].
c. Do-not peel the tape that secures the display cable [3].
d. Disconnect the display cable from the connector on the display panel [4].
Using your tablet
19
To Next Page
Loading...
