Installing the antenna module
1. Insert the antenna module into the slot on the back cover of the tablet.
2. Tighten the M1.6 x 3 screw to secure the antenna module.
3. Route the antenna cables to the routing channels.
4. Affix the tape and the conductive tapes to secure the antenna cables.
5. Install the:
a. heat sink
b. rear facing camera
c. front facing camera
d. system fan
e. WLAN card
f. SSD card
g. battery
h. display panel
i. uSIM/microSD card
NOTE: uSIM card is installed only on tablets shipping with WWAN module.
6. Follow the procedure in After working inside your tablet.
USH board
Removing the USH board
1. Follow the procedure in Before working inside your tablet.
Using your tablet
39
To Next Page
Loading...
