Installing the display cable
1. Connect the display cable to connector on the display panel.
2. Affix the tape to secure the display cable to the display panel.
3. Connect the touch module cable to connector on the display panel.
4. Affix the tape to secure the touch module cable to the display panel.
5. Install the:
a. display panel
b. uSIM/microSD card
NOTE: uSIM card is installed only on tablets shipping with WWAN module.
6. Follow the procedure in After working inside your tablet.
PCIe Solid State Drive (SSD)
Removing the SSD module
1. Follow the procedure in Before working inside your tablet.
2. Remove the:
a. uSIM/microSD card
NOTE: uSIM card slot is available only on tablets shipping with WWAN module.
b. display panel
3. To remove the SSD module:
a. Remove the M2.0 x 2.5 screw securing the SSD shield [1].
b. Lift the SSD shield away from the tablet [2].
c. Slide and lift the SSD module from the slot on the tablet [3].
20
Using your tablet
To Next Page
Loading...
