2. Replace the M1.6 x 3.0 screw to secure the rear camera module.
3. Connect the rear camera cable to the system board.
4. Install the:
a. front camera
b. display panel
c. uSIM/microSD
NOTE: uSIM card is installed only on tablets shipping with WWAN module.
5. Follow the procedure in After working inside your tablet.
Smart Card Cage
Removing the smart card cage
NOTE: Always remove the smart card from the smart card reader.
1. Follow the procedure in Before working inside your tablet.
2. Remove the:
a. uSIM/microSD card
NOTE: uSIM card slot is available only on tablets shipping with WWAN module.
b. display panel
3. To disconnect the cables:
a. Disconnect the smart card cable from the smart card cage [1].
b. Remove the M2.0 x 2.5 screws from the smart card module [2].
c. Lift the smart card cage from the tablet [3].
Using your tablet
31
To Next Page
Loading...
