NOTE: If you can easily disconnect the coin cell battery cable from beneath the connector on the system board, you
need not remove the system board to remove the coin cell battery.
Installing the coin cell battery
1. Insert the coin cell battery to the slot on and affix it to the back cover.
2. Connect the coin cell battery cable to the connector beneath the system board.
3. Install the:
a. battery
b. display panel
c. uSIM/microSD card
NOTE: uSIM card is installed only on tablets shipping with WWAN module.
4. Follow the procedure in After working inside your tablet.
Antenna
Removing the antenna module
1. Follow the procedure in Before working inside your tablet.
2. Remove:
a. uSIM and/or microSD card
NOTE: uSIM card slot is available only on tablets shipping with WWAN module.
b. display panel
c. battery
d. front facing camera
e. rear facing camera
Using your tablet
37
To Next Page
Loading...
