Installing the system fan
1. Align the system fan with screw holders on the system board.
2. Replace the M2.0 x 3.0 screws to secure the system fan to the system board.
3. Connect the system fan cable to the system board.
4. Install the:
a. display panel
NOTE: uSIM card is installed only on tablets shipping with WWAN module.
b. uSIM/microSD card
5. Follow the procedure in After working inside your tablet.
Heat sink
Removing heat sink assembly
1. Follow the procedure in Before working inside your tablet.
2. Remove the:
a. Micro-SIM and/or microSD card
NOTE: Micro-SIM card slot is available only on tablets shipping with WWAN module.
b. Display panel
26
Using your tablet
To Next Page
Loading...
