3. To remove the heat sink assembly:
a. Peel the conductive tapes that secure the shielding cover [1].
NOTE: Ensure to peel off the tape carefully, as any damage to the tape will need to raise a new order for conductive
tapes. The tape secures the IR camera cable from any damage. Ensure to fix the tapes while installing or replacing
the component. Gently remove the 4 conductive tapes, so that the conductive tapes can be reused.
b. Lift the shielding covers that secure the heat sink assembly [2,3].
NOTE: Peel the black tape / copper tape that secure the IR camera cable for model shipped with IR camera
(optional).
4. To remove the heat sink assembly:
a. Loosen the M2.0 x 2.5 captive screws that secure the heat sink assembly to the tablet [1].
NOTE: Remove the screws in the order of the callout numbers [1, 2, 3, 4] as indicated on the heat sink.
b. Lift the heat sink assembly from the tablet [2].
Using your tablet
27
To Next Page
Loading...
