CAUTION: Attempt to retrieve the primary SSD carrier from an operational computer can cause operating
system crash and potential data loss.
2. Remove the: Batteries.
3. Release the SSD carrier by sliding the blue hard drive release latch [1] towards right.
4. Slide the SSD carrier out of the computer using the blue pull tab [2] out of the computer.
Installing the Primary SSD carrier
1. Insert the primary SSD carrier [1] in to the computer.
2. Push the carrier into the slot until the blue tab clicks and close the right I/O door [2].
3. Install the: Batteries
4. Follow the procedure in After working inside your computer.
Removing and installing components
83
To Next Page
Loading...
