Dell Latitude 5424 Rugged - Page 98

3. Install the RF bracket [1] on the system board and secure it using the single 'M2.5*5' screw [2].
4. Route the aux cables for WLAN and WWAN cards through the RF bracket [3].
5. Connect the antennae cable [4] on GPS module and route the main antennae cables [5] through the RF bracket.
6. Install the:
a. Rear I/O board
b. Bottom Chassis Cover
c. Batteries
7. Follow the procedure in After working inside your computer.
98
Removing and installing components