Installing smart card reader board
1. Insert the smart card reader board to align with the tabs on the chassis.
2. Replace the 2 (M2x3) screws to secure the smart card reader board to the system.
3. Connect the touchpad cable to its connector on the system board.
4. Affix the smart card reader board cable and connect the cable to the connector.
5. Install the:
a. chassis frame
b. WWAN card (optional)
c. WLAN card
d. SSD frame
e. SSD card
f. hard drive
g. battery
h. base cover
6. Follow the procedure in After working inside your computer.
Speaker
Removing the speaker
1. Follow the procedure in Before working inside your computer.
34
Removing and installing components
To Next Page
Loading...
