Installing display panel
1. Connect the display cable to the connector and affix the adhesive strip.
2. Affix the conductive tape to secure the display cable.
3. Replace the display panel to align with the screw holders on the display assembly.
4. Replace the four M2x3 screws to secure the display panel to the display back cover.
5. Install the:
a. display bezel
b. display assembly
c. display hinge cover
d. WLAN card
e. WWAN card (optional)
f. battery
g. base cover
6. Follow the procedure in After working inside your computer.
Display (eDP) cable
Removing display cable
1. Follow the procedure in Before working inside your computer.
2. Remove the:
Removing and installing components
47
To Next Page
Loading...
