Dell Latitude 5490 - Page 37

4. To release the system board:
a. Flip over the system and remove the two M2x3 screws that secure the display cable bracket in place [1].
b. Lift the metal display cable bracket from the system [2].
c. Disconnect the display cables from the connectors on the system board [3,4].
d. Disconnect the power connector port cable from the connector on the system board [5].
e. Remove the two M2x5 screws that secure the Type-C USB bracket in place [6].
NOTE: The metal bracket secures the DisplayPort over USB Type-C.
f. Lift the metal bracket away from the system [7].
Removing and installing components
37