Installing the base cover
1 Align the base cover with the screw holders on the laptop .
2 Press the edges of the cover until it clicks into place.
3 Tighten the M2x5 screws to secure the base cover to the laptop.
4 Follow the procedure in After working inside your computer.
Battery
Removing the battery
NOTE
: A 4-cell 68Whr battery has only 1 screw.
1 Follow the procedure in Before working inside your computer.
2 Remove the base cover.
3 To remove the battery:
a Disconnect the battery cable from the connector on the system board [1].
b Loosen the M2x5 screw (1) that secure the battery to the laptop [2].
c Lift the battery away from the laptop chassis [3].
14
Removing and installing components
To Next Page
Loading...
