Installing the system fan
1 Place the system fan on the system board and align the system fan on the screw holders.
2 Tighten the M2.0x3.0 screws to secure the heat sink to the system board.
3 Connect the fan cable to the connector on the system board.
4 Install the:
a battery
b base cover
5 Follow the procedure in After working inside your computer.
Power connector port
Removing the power connector port
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a base cover
b battery
3 To remove the power connector port:
a Disconnect the power connector port cable from the connector on the system board [1].
NOTE
: Use a plastic scribe to release the cable from the connector. Do not pull the cable as it may result in breakage.
b Remove the M2.0x3.0 screw to release the metal bracket that secures the power connector port [2].
c Remove the metal bracket that secures the power connector port [3].
d Lift the power connector port away from the laptop [4].
Removing and installing components
29
To Next Page
Loading...
