a SIM card module
b base cover
c battery
d WLAN card
e WWAN card
f SSD card or hard drive
g memory module
h heat sink
i coin cell battery
j Power connector port
k chassis frame
3 To release the system board:
a Remove the M2.0x3.0 screws that secures the metal bracket to the system board [1].
b Lift the metal bracket that secures the display cable to the system board [ 2].
c Disconnect the display cable from the connectors on the system board [3].
d Disconnect the power cable [4].
4 To remove the system board:
a Disconnect the LED board, mother board and touchpad cable from the connectors on the system board [1].
b Remove the M2.0x5.0 screws (2) that secure the metal bracket to the system board and lift the bracket away from the system
board [2,3].
NOTE
: The metal bracket referred is the USB-C port bracket.
Removing and installing components 33
To Next Page
Loading...
