Installing the keyboard
1 Hold the keyboard and route the keyboard cable and the keyboard backlight cable through the palmrest in the system.
2 Align the keyboard with the screw holders on the system.
3 Replace the M2*2 screws (6) to secure the keyboard to the system.
4 Turn the system and connect the keyboard cable and the keyboard backlight cable to the connector in the system.
5 If you have not removed the battery, you must connect the battery cable to the system board.
6 Install the:
a keyboard lattice
b battery
c base cover
7 Follow the procedure in After working inside your computer.
Installing the keyboard trim
1 Align the keyboard trim with the tabs on the computer and press the keyboard until the keyboard clicks into place.
2 Follow the procedure in After working inside your system.
Heat sink
Removing the heat sink
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a base cover
b battery
3 To remove the heat sink :
a Remove the M2.0x3.0 screws (4) that secures the heat sink to the system board [1].
NOTE
: Remove the screws that secure the heat sink sink .
b Lift the heat sink away from the system board [2].
Removing and installing components
27
To Next Page
Loading...
