CAUTION: Do not open the display panel more than 90 degrees as this may damage the display cable.
9 Before removing display panel:
a Gently place the bottom edge of the display panel inside the bottom edge of the rear cover.
b Flip open the display panel to a 180 degree angle and lay it at on the surface.
10 To disconnect the display cable:
a Remove the M1.6x2.5 (1) screw that secures the metal bracket on the system board [1].
b Lift the metal tab and disconnect the battery cable [2].
c Remove the adhesive tape that secure the display cable on the system board [3].
d Remove the M1.6x2.5 (2) screws that secures display cable [4].
Removing and Installing components
21
To Next Page
Loading...
